i hav a cartilage piercing and i bought a new loop earing to put in it but my hole is too small for the earring to fit….if i go to where i got it done will they poke the earring through or will they make the hole larger??
Your Comments
3 Comments so far
Share your view
Post a comment
- Industrial Piercing Question (for Those Who Already Have One)?
- How Much Would It Cost And Where Can I Get My Tattoo Removed?
- What Would You Relate The Pain Of A Chest Tattoo To?
- What Place Besides A Tattoo Shop Can My Get My Belly Button Pierced?
- What Do Guys And Girls Find Sexy..tat + Piercing Question Too?
- What The Requirements To Open A Tattoo/ Body Piercing Shop In Alabama?
- How Deep Does A Tattoo Needle Go?
- Body Piercing! Does It Hurt Real Bad To Get Your Private Female Parts Done?
- Is This A Good Tattoo And Where Should I Get It? What Else Should I Add?
- 10 Points For Best Answer! Tounge Piercing Question.?
-
Melander: Only in a TATOO SHOP...AND >>>only if the 'TATOO'...
-
Timberley: 1. The pain for me was terrible. I went in thinkin...
-
-
-
© 2010 InkedHUMANS. Hosted by GigaPros.
Design by Imburne Technical Advisors
Im kinda in the same situation… and from what i have read… It all depends on how much bigger the new earring is.
If you are going from a 20-22g piercing hole, than you can basically slip a 18g in without having to have it done by a proffesional….
Still I think you should just to make sure you dont cause any damage.
Good Luck!
if you want that earring in your could probably poke it through yourself, or just buy jewelry that fits the hole, unless you want the hole larger.
theyll make the hole larger most likely. but if you wanna do it yourself buy ear rings that barely fit, squeeze them in, then keep getting bigger ones until the loops fit